300-115試験を取得するのが勉強者のIT技術と能力を証明できるだけでなく、社会的地位を高める一つの方法です。Killtest 300-115試験では、CCNP認定を構成するために必要なスキルを検証します。300-115試験はIT環境を管理し、安全確保を行うための手段を提供することで、勉強者がITサービスを柔軟に行えるよう支援しています。Killtestは一番人気があるサイトの一つで、CCNP認定の分野にとても有名です。いつでも300-115試験を受けて、最初の試みに300-115試験のパスすることを保障します。Killtestの300-115試験問題集は試すCCNP認定300-115試験に自信を持って勉強者の能力を高めて、正しい知識と技術を身につけている方だけに資格が得られるようにして、品質と価値は最も最新し、きっとパスすることが保証します。
Share some CCNP 300-115 exam questions and answers below.
Which statement about the use of SDM templates in a Cisco switch is true?
A. SDM templates are used to configure system resources in the switch to optimize support for specific features, depending on how the switch is used in the network.
B. SDM templates are used to create Layer 3 interfaces (switch virtual interfaces) to permit hosts in one VLAN to communicate with hosts in another VLAN.
C. SDM templates are used to configure ACLs that protect networks and specific hosts from unnecessary or unwanted traffic.
D. SDM templates are used to configure a set of ACLs that allows the users to manage the flow of traffic handled by the route processor.
E. SDM templates are configured by accessing the switch using the web interface.
Answer: A
After the implementation of several different types of switches from different vendors, a network engineer notices that directly connected devices that use Cisco Discovery Protocol are not visible.
Which vendor-neutral protocol could be used to resolve this issue?
A. Local Area Mobility
B. Link Layer Discovery Protocol
C. NetFlow
D. Directed Response Protocol
Answer: B
When SDM templates are configured, which action must be performed for the configuration to take effect?
A: reload
B: shutdown
C: write memory
D: backup config
Answer: A
A network engineer tries to configure storm control on an EtherChannel bundle.
What is the result of the configuration?
A. The storm control settings will appear on the EtherChannel, but not on the associated physical ports.
B. The configuration will be rejected because storm control is not supported for EtherChannel.
C. The storm control configuration will be accepted, but will only be present on the physical interfaces.
D. The settings will be applied to the EtherChannel bundle and all associated physical interfaces.
Answer: D
Which technique allows specific VLANs to be strictly permitted by the administrator?
A. VTP pruning
B. transparent bridging
C. trunk allowed VLANs
D. VLAN access-list
E. L2P tunneling
Answer: C
Which statement about Cisco devices learning about each other through Cisco Discovery Protocol is true?
A. Each device sends periodic advertisements to multicast address 01:00:0C:CC:CC:CC.
B. Each device broadcasts periodic advertisements to all of its neighbors.
C. Each device sends periodic advertisements to a central device that builds the network topology.
D. Each device sends periodic advertisements to all IP addresses in its ARP table.
Answer: A
Which SDM template disables routing and supports the maximum number of unicast MAC addresses?
A. VLAN
B. access
C. default
D. routing
Answer: A
A network engineer must set the load balance method on an existing port channel.
Which action must be done to apply a new load balancing method?
A. Configure the new load balancing method using port-channel load-balance.
B. Adjust the switch SDM back to "default".
C. Ensure that IP CEF is enabled globally to support all load balancing methods.
D. Upgrade the PFC to support the latest load balancing methods.
Answer: A
Which statement about the MAC address sticky entries in the switch when the copy run start command is entered is true?
A: A sticky MAC address is retained when the switch reboots.
B: A sticky MAC address can be a unicast or multicast address.
C: A sticky MAC address is lost when the switch reboots.
D: A sticky MAC address ages out of the MAC address table after 600 seconds.
Answer: A
Pilot testing of the new switching infrastructure finds that when the root port is lost, STP immediately replaces the root port with an alternative root port.
Which spanning-tree technology is used to accomplish backup root port selection?
A. PVST+
B. PortFast
C. BackboneFast
D. UplinkFast
E. Loop Guard
F. UDLD
Answer: D
Killtestはその近道を提供し、勉強者の大切の時間と労力も節約します。KilltestはCCNP認証のImplementing Cisco IP Switched Networks試験問題集に向けてもっともよい問題集を研究しています。Killtestが提供した資料は最も全面的で、命中率が最高です。
人間はそれぞれの夢を持っているんです。適当な方法を採用する限り、夢を現実にすることができます。KilltestのCiscoの300-115試験参考資料を利用したら、試験に合格することができます。その資料は最完全かつ最新で、合格率が非常に高いということで人々に知られています。それを持っていたら、受験者は時間とエネルギーを節約することができます。CiscoCCNP資格認定はITエンジニアのスキルを証明するための認定資格として広く認知されています。認定を雇用の際の重要要素として見なしていることがわかりました。このCCNP資格を取得したければ、必須300-115科目に合格しなければいけません。300-115試験の取得が技術、知恵及び実力を証明できて、認定書を手に入れたら、気に入手高給の職業を就けます。
